Social media

Javascript is required to use HSE website social media functionality.

Company fined after worker killed in offshore incident

Date:
2 February 2015

An offshore services company has been fined for serious safety failings following an incident in which a worker died after plunging 23 metres from a platform into the sea.

Lee Bertram, then 37, from Newcastle, Tyne and Wear, was working for Bilfinger Salamis UK Limited on a platform in the North Sea when the incident happened on 16 June 2011.

Mr Bertram was using ropes to access below the deck and carry out a sweep for dropped objects that could fall into the water, potentially injuring divers working in the sea below.

Aberdeen Sheriff Court heard today (2 Feb) that Mr Bertram had successfully abseiled around an area about eight square feet taking photographs and removing debris. He then started back up the ropes and was a metre from the top when he noticed a beam clamp that needed to be removed, which he did with a hammer.

As Mr Bertram started his ascent to the deck he had to stop, suspended, just below the hatch in order to open the rope protector so he could move his ‘jammer’ up the working rope and past the edge allowing him to move through the hatch.

However, as he pushed down on his foot loop to come up through the hatch both the main and the safety rope sheared against the sharp edge and he fell to the sea – a distance of 23 metres – striking steelwork as he fell.

When he landed in the water, his lifejacket inflated and a rescue vessel was deployed.  Despite showing some signs of consciousness during the rescue he died from his injuries before reaching the onsite hospital.

An investigation by the Health and Safety Executive (HSE) found that the job Mr Bertram was undertaking had not been properly planned and was contrary both to industry (IRATA) guidelines and the company’s own procedures.

Inspectors concluded that had the work been properly planned the edge of the hatch would have been identified as being sharp and the risk of rigged ropes coming into contact with it could have been prevented. Instead the ropes were rigged against the edge leading them to be severed.

Bilfinger Salamis UK Limited of Pinbush Road, Lowestoft, Suffolk, was fined £100,000 after pleading guilty to breaching Regulation 4 of the Work at Height Regulations 2005.

Following the case, HSE Inspector Katie McCabe, said:

“This was a tragic incident and Mr Bertram’s death could have been prevented had Billfinger Salamis planned the job correctly and put suitable safety measures in place.

“Assessing the risks of that job properly would have identified that the potentially sharp edge presented a very clear danger to anyone suspended and working on ropes rigged against it.

“However, the company failed to do this so failed to take safety precautions and instead, Mr Bertram fell to his death.”

For more information about working safely at height log onto the HSE website at: http://www.hse.gov.uk/work-at-height/index.htm

Notes to Editors:

1. The Health and Safety Executive (HSE) is Britain’s national regulator for workplace health and safety. It aims to reduce work-related death, injury and ill health. It does so through research, information and advice, promoting training; new or revised regulations and codes of practice, and working with local authority partners by inspection, investigation and enforcement. www.hse.gov.uk

2. In Scotland the Crown Office and Procurator Fiscal Service has sole responsibility for the raising of criminal proceedings for breaches of health and safety legislation.

3. Regulation 4 of the Work at Height Regulations 2005 states: “Every employer shall ensure that work at height is – (a) properly planned; (b) appropriately supervised; and (c) carried out in a manner which is so far as is reasonably practicable safe.”

4. HSE news releases are available at press.hse.gov.uk

Media contacts

Journalists should approach HSE press office with any queries on regional press releases.