Social media

Javascript is required to use HSE website social media functionality.

Three to pay £590,000 after father’s death at Yorkshire Mining Museum

Date:
16 December 2014

Yorkshire’s National Coal Mining Museum Trust and two companies were today (16 Dec) ordered to pay a total of £590,000 in fines and costs after a worker was crushed and killed at the museum in 2011.

Father-of-two Michael Buckingham, 58, of Grimethorpe, near Barnsley, died after he became trapped between a tunnel construction machine and a dumper loader that he was operating. The fatal incident, on 25 January 2011, happened 138 metres below ground at the museum’s site at Caphouse colliery in Wakefield.

Sheffield Crown Court heard that Mr Buckingham, an experienced miner and electrician, was part of a team engaged in the second phase of a £2.7 million improvement project. This involved constructing 140 metres of new tunnels to revitalise the visitors’ tour and increase the number of exhibition galleries.

At the time, the museum trust had hired specialist contractor Amalgamated Construction Ltd (AMCO), of Barnsley, to build the tunnels. AMCO, which employed Mr Buckingham, was using the two machines, both supplied by Metal Innovations Ltd (MIL), of Cowbridge in Wales.

Mr Buckingham sustained fatal crush injuries when he became trapped between the tunnel construction machine and the forward-tipping dumper – a mineral carrying machine – that he had been operating.

The incident was investigated by the Health and Safety Executive’s (HSE) specialist mining division, which served a prohibition notice on equipment supplier Metal Innovations after inspectors found the dumper was unsafe.

Counsel for HSE, Rex Tedd QC, told the court that HSE identified that the dumper:

•  did not have a readily-accessible emergency stop function;

•  did not meet essential safety requirements relating to the design and supply or machinery; and

• posed a clearly foreseeable risk that it would entrap the operator.

He said equipment supplier MIL was responsible for failing to supply equipment that met the essential health and safety requirements required of all new machinery. Instead, it had supplied a machine that was patently dangerous in several ways.

The contractor, AMCO, had failed to carry out a suitable risk assessment of the machine or the work activities, including the interactions of the workers and equipment; and had put an unsafe machine to work, exposing staff to substantial risk.

The court was told that the Museum Trust’s safety breach centred on its failing to ensure that the mine was run in accordance with all relevant safety regulations. Unlike those of the other two defendants, the breach had not played a causative role in the loss of Mr Buckingham’s life.

Amalgamated Construction Ltd, of Whaley Road, Barugh Green, Barnsley, South Yorkshire, was fined a total of £110,000 with £245,000 to pay in costs after pleading guilty to a breach of the Health & Safety at Work etc Act plus a breach of the Management of Health and Safety at Work Regulations.

Metal Innovations Ltd, of Unit 54 Business Park, Llandow, Cowbridge, Wales, was fined £80,000 with £110,000 in costs after admitting a breach of the Health and Safety at Work etc Act in connection with the supply of machinery. Both companies were guilty of breaches that were clearly connected to the loss of Mr Buckingham’s life.

The museum trust was fined £10,000 with £35,000 in costs to pay after admitting breaching the Management and Administration of Safety and Health at Mines Regulations 1993. The three defendants had earlier entered guilty pleas to the offences.

Following the sentencing, Mr Buckingham’s widow, Gail, said:

“Mick was a hard-working, loving husband and family man who will always be missed. Although we are satisfied with the outcome, we would have liked responsibility to have been accepted a long time ago.”

HSE Principal Inspector for Mines Paul Bradley said:

“There were several factors that came into play that led to the very tragic death of a much-loved and respected family man.  It was an incident that could have been prevented but all three parties had a role to play in how it went badly wrong.  However, the Trust’s failure did not play a direct role in the tragic loss of life, unlike the combination of failures of the other two defendants.

“It was clearly foreseeable that entrapment and crushing could result from the use of this mobile machinery, given how the work was being carried out. This meant Mr Buckingham had to walk backwards on occasions and operate close to other equipment within the confines of an underground roadway. Low-cost solutions could have addressed these hazards and such solutions were readily available.

“The MIL-supplied forward tipping dumper did not conform to design standards or safety requirements, and the dumper’s canopy both reduced the potential for escape from the incident and caused severe injuries to Mr Buckingham. Other equipment supplied or used by AMCO and Metal Innovations had integral emergency stop facilities within easy reach.

“It was also clear from the investigation that Mr Buckingham had not benefited from suitable and sufficient training in the use of the dumper.

“Machines and equipment must be supplied free from defects and accord with safety provisions. They must be assessed in the work environment and a system of work devised for their safe use.”

At the time of the incident, no members of the public were exposed to any risks. All mining activity was taking place overnight.

Notes to Editors:

Photos: Mick Buckingham; the two machines supplied by Metal Innovations, with the dumper that was found to be unsafe pictured outside the mine.

  1. The Health and Safety Executive is Britain’s national regulator for workplace health and safety. It aims to reduce work-related death, injury and ill health. It does so through research, information and advice; promoting training; new or revised regulations and codes of practice; and working with local authority partners by inspection, investigation and enforcement. www.hse.gov.uk
  2. Section 2(1) of the Health and Safety at Work etc Act 1974 states: “It shall be the duty of every employer to ensure, so far as is reasonably practicable, the health, safety and welfare at work of all his employees.”
  3. Section 6(1)(a) of the same Act states: “It shall be the duty of any person who designs, manufactures, imports or supplies any article for use at work to ensure, so far as is reasonably practicable, that the article is so designed and constructed that it will be safe and without risks to health at all times when it is being set, used, cleaned or maintained by a person at work.”
  4. Regulation 3 of the Management of Health and Safety at Work Regulations states: “Every employer shall make a suitable and sufficient assessment of the risks to the health and safety of his employees to which they are exposed whilst they are at work; and the risks to the health and safety of persons not in his employment arising out of or in connection with the conduct by him of his undertaking.
  5. Regulation 6(2)(b) of the Management and Administration of Safety and Health at Mines Regulations 1993 states: “It shall be the duty of the owner of the mine to  secure, so far as is practicable, that the mine is managed and worked in accordance with the relevant statutory provisions (which are applicable to the mine) and is so planned and laid out as to enable that purpose to be readily secured.”

Media contacts

Journalists should approach HSE press office with any queries on regional press releases.